Fabricsmart Iw Size Setting; Diagnostic Mode; Quicksmart, Washsmart, Mw, Gw And Wa Models - Fisher & Paykel SMARTDRIVE Service Manual

421827
4.2

FabricSmart IW Size setting

To set the size, turn the mains on at the supply point and off at the console. Press and hold the
Lifestyles/Options
will present the option of Medium or Large in the LCD screen. Highlight the correct size using
either Scroll arrows
automatically saved.
If the size setting is wrong, the machine will have the following settings incorrect: -

The Auto Water Levels chosen may be incorrect.

The High Water Level may be incorrect by as much as 40mm.

The wash profiles may be incorrect resulting in poor wash performance or vigorous wash
actions causing tangling, splash over or excess linting.

Water saver settings.
5

DIAGNOSTIC MODE

To enter diagnostic mode, for each of the different models follow the steps below.
5.1

QuickSmart, WashSmart, MW, GW and WA Models

1. Turn the power on at the power point but off at the machine.
2. Press and hold the WASH TEMPERATURE DOWN button and then press the POWER button
until the machine gives 2 short beeps and lights up.
3. Release the buttons after the beeps as the beeps indicate diagnostic mode has been entered.
5.1.1 Last Fault Data
When in diagnostic mode the last fault can be found by pressing the SPIN SPEED UP or DOWN
buttons until the HOLD and SLOW lights are illuminated. Binary can then be read from the wash
progress lights.
5.1.2 Drain Pump Test
When in diagnostic mode to activate the drain-pump press the REGULAR button. To deactivate
the pump, press REGULAR button again.
and the Left Arrow
or then power off the display with the Power button, your selection is
128 64 32
button until the size setting screen is displayed. This
16 8 4
26
2 1