Restart/Recycle Features Permanently Programmed; Restart / Recycle Table Led - Fisher & Paykel AQUASMART WL37T26CW2 Service Manual

Hide thumbs Also See for AQUASMART WL37T26CW2:
Table of Contents

Advertisement

7.6

Restart/Recycle Features Permanently Programmed

It is possible for the Restart Feature to be permanently disabled, or the Recycle Feature to be
permanently enabled, or a combination of both to be permanently programmed into the memory of
the electronics so that in the event of a power cut the electronics will remember the setting.
The factory settings are:
Restart is enabled
Recycle is disabled
If a machine is encountered with the Restart/Recycle features not set to the factory defaults, the
machine must be re-programmed using following steps;
Dispensing Model
1.
Enter DIAGNOSTIC MODE 1 by pressing and holding the HI-EFFICIENCY button and then
pressing the POWER button.
2.
To enable/disable the Restart feature permanently, press and hold the FABRIC
SOFTENER button for three seconds until a beep is heard.
3.
To enable/disable the Recycle feature permanently, press and hold the SOAK button for
three seconds until a beep is heard.
Non-Dispensing Model
1. Enter DIAGNOSTIC MODE 2 by pressing and holding the EASY IRON button and then
pressing the POWER button
2. To enable/disable the Restart feature permanently, press and hold the TEMPERATURE
button for three seconds until a beep is heard.
3. To enable/disable the Recycle feature permanently, press and hold the SOAK button for
three seconds until a beep is heard.
NOTE - This feature is designed as a service aid only and should be SET TO THE FACTORY
SETTINGS in the customer's home. To return to normal operation, and to return the recycle
feature to the factory setting, switch the machine off at the wall or disconnect from the
mains supply.
7.7

Restart / Recycle Table LED

The LED Aquasmart uses a combination of Power button and Wash Cycle LED's to indicate which
state has been selected or not selected. The table below explains the state the of LED's when the
machine is on at the wall but off at the machine.
LED'S Off (Factory Default)
Power & Wash Cycle LED's Flashing
Power LED Flashing
Wash Cycle LED's Flashing
Restart on
Recycle off
Restart off
Recycle on
Restart off
Recycle off
Restart on
Recycle on
41
478182

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents