User Button; Setting The User Button - Panasonic AG-DVX200PJ Operating Instructions Manual

MENU
: [RECORD SETUP] # [EXT TC LINK] # [SLAVE]
≥ [TCG] will be set to [FREE RUN].
5
(On the slave device)
Press the RESET/TC SET button.
≥ [TC LINK OK] will be displayed and the time code will be synchronized with that of the master
device.
≥ When the time code is not synchronized correctly, [TC LINK NG] is displayed.
≥ To cancel the operation without synchronizing the time code, touch [EXIT].
≥ Use a commercially-available, double-shielded BNC cable equivalent to 5C-FB.
≥ [EXT TC LINK] cannot be set to [SLAVE] in the following cases:
j In Variable Frame Rate Mode
j During the Interval Recording
Recording

USER button

Each of the USER button can register one function from the 38 available functions.
≥ There are eight USER buttons (USER1 to USER8) on the main body and four USER button icons
(USER9 to USER12) displayed on the LCD monitor.

Setting the USER button

1
Select the menu.
MENU
: [USER SW] # [USER1] to [USER12]
≥ It is not possible to register functions to [USER9] to [USER12] in Playback Mode.
2
Touch the item to register.
≥ For the functions of the USER button that can be registered, refer to page 76.
≥ Touch [INHIBIT] if not registering.
≥ Next (Previous) page can be displayed by touching
3
Touch [EXIT] to complete the setting.
≥ The tables below show the default settings.
USER1 button
USER2 button
USER3 button
USER4 button
USER5 button
USER6 button
≥ Performing [ALL] in [INITIAL SET] restores these default settings.
(l 91)
(l 162)
[DRS]
[ATW]
[BACKLIGHT]
[FOCUS MACRO]
[O.I.S.]
[ZEBRA]
/ .
USER7 button
USER8 button
USER9 button
USER10 button
USER11 button
USER12 button
- 74 -
[WFM]
[REC CHECK]
[FRZ FRAME]
[EVF/LCD DETAIL]
[ATW LOCK]
[MENU]
(l 178)