Panasonic AG-DVX200PJ Operating Instructions Manual page 165

≥ In the following cases, even when [TIME STAMP] is set to [ON], the date and time of recording
are not displayed:
j When [OUTPUT BITS] is set to [4:2:2(10bit)]
j When [REC FORMAT] is set to [SA 480/59.94i] or [SA 576/50.00i]
j When [2 SLOTS FUNC.] is set to [DUAL CODEC]
j When [DATE/TIME] is set to [OFF]
j During Freeze Frame
j In Variable Frame Rate Mode
j When this unit is connected to the SDI OUT terminal of the external device and the external
output resolution is set to PsF
≥ Even when [VIDEO OUT OSD] is set to [OFF], the date and time of recording are displayed on
the external monitor screen.
≥ It is not possible to stamp the date and time of recording during normal still picture recording.
≥ The date and time of recording displayed during [TIME STAMP] recording and the date and time
displayed during the playback of the image may not exactly be the same.
[DF MODE]
≥ Set [SYSTEM FREQ] to [59.94Hz].
[DF]/[NDF]
Selects the compensation mode for the time code.
[TCG]
[FREE RUN]/[REC RUN]
Sets the way the time code will move.
[TC PRESET]
Initial value of the time code can be set.
[UB PRESET]
≥ Set [REC MODE] to [AVCHD].
User Information can be set.
[EXT TC LINK]
[MASTER]/[SLAVE]
You can synchronize the time code of the external device with that of this unit.
(l 81)
(l 91)
(l 116)
(l 115)
(l 141)
(l 71)
(l 72)
(l 141)
(l 72)
- 165 -
(l
(l 159)
(l 71)
142)
(l 73)