Panasonic AG-DVX200PJ Operating Instructions Manual page 53

Using Focus Transition
≥ Select the [FOCUS TRANSITION] menu.
≥ Register [FOCUS TRANS] to a USER button.
1
Switch to Manual Focus Mode.
2
Press the USER button to which [
the applicable USER button icon.
3
Touch a registered item ([1]s[3]).
≥ Focus Transition will start. Focus will shift slowly from the
current position to the registered position. This will take a
few seconds. (l 54)
≥ As the focus shifts, the Focus Transition bar will move
from [S] to [E].
4
Touch [EXIT] to exit Focus Transition.
≥ If you move this unit a lot after setting the focus position, focus may not stop at the set position.
≥ When Focus Transition is in use, focus cannot be adjusted with the focus ring.
≥ Focus Transition is not available in the following cases:
j When Auto Focus is used
j During Freeze Frame
j In Variable Frame Rate Mode
j When color bars are displayed.
j When a remote control (commercially-available) is connected
≥ Focus Transition settings are canceled in the following cases. To use Focus Transition again,
register a focus position again.
j If you operate the zoom
j If you enable or disable Infrared Recording Mode
≥ You can only use the following USER button functions by pressing one of the USER buttons 5 s 8
when Focus Transition is in use
j [FOCUS ASSIST]
j [FOCUS TRANSITION]
j [INFRARED REC]
j [BACKGROUND]
(
l 52
(l 44)
FOCUS TRANSITION
(l 81)
(l 91)
(l 95)
(l 52)
(l 74):
- 53 -
)
(l 74)
] is registered or touch

A [EXIT]
B Focus Transition bar
(l 113)
j [PRE-REC]
j [EVF ON/OFF]
j [AUTO REC]
j [MENU]
MF50 MF50 MF50
S E
1 2 3
