Section 6 − Setup And Operation; Safety Equipment; Ih/Ts Setup; Select Power Source - Miller Electric IH Owner's Manual

SECTION 6 − SETUP AND OPERATION

6-1. Safety Equipment

6-2. IH/TS Setup

6-2-1.

Select Power Source

Energize the power source, cooler, and IH/TS. A power source selection will appear in the top right corner of the
IH/TS front panel Parameter Display. Press the recessed Power Source Select button on the IH/TS rear panel to
toggle through and select the appropriate power source maximum output. This selection will provide the proper out-
put scaling in the parameter display screen for the power source that is attached to the IH/TS.
OM-203 185 Page 16
1
Parameter Display
0 . 0 K W P w r P S
0 A m p s ( r m s )
0 V o l t s ( r m s )
1 2 . 5 K H s F r e q u e n c y
Wear
2
operation:
1. Dry, Insulating Gloves
2. Safety Glasses With Side
Shields
DO NOT wear rings or watches
during operation.
Power Source Max Output
2 5
the following during
sb3.1* 1/94