Table of Contents
Advertisement
4-7. Connecting External Device
Tools Needed:
11/16 in
OM-203 185 Page 12
1
2
6
5
4
3
The IH/TS must have (as a
minimum)
one
thermocouple
connected to receptacle TC1. If
multiple
thermocouples
are
desired, either
use
individual
thermocouple
plugs
or
the
thermocouple extension cable.
To connect thermocouples to the
control, proceed as follows:
Turn Off power source.
1. Temperature Controller
2. Thermocouple Receptacles
3. Individual Thermocouple Plug
4. Thermocouple Extension
Cable
Align plug pins with receptacle
sockets
and
push
plug
into
receptacle.
5. Coolant Line From Coil
6. Coolant Line To Cooler
"Coolant In" Port
The IH/TS is supplied with an
internal
coolant
flow
switch.
Coolant hoses must be connected
to the IH/TS for proper operation.
Connect coolant hoses (supplied
with post-heat systems) to coolant
fittings on unit as described in
Section 4-5.
Ref. 803 003-B
Advertisement
Table of Contents
Troubleshooting
