Connecting 25Kw System Cords And Cables - Miller Electric IH Owner's Manual

4-5. Connecting 25kW System Cords And Cables

Blue
Front
Connect the power output cable and
coolant lines as shown.
Connect 110-volt power cable as shown.
Plug the 110-volt cooler power cord into
the duplex at the rear of the power source
cart. On the 25kW system, the cooler must
be plugged into the right side duplex. This
is identified with a label that reads
"switched receptacle." The ON-OFF
switch located to the left operates this
OM-203 185 Page 10
Hose From Cooler To
Power Source
14-Pin
Control Cable
Output
Connectors
Blue
Yellow
110 Volt From Hose From
Cooler IH/TS To
Cooler
plug.
The IH/TS Control is plugged in the left
side duplex. Do not use these duplex
connections for operating auxiliary tools,
such as grinders, drills, lights, etc.
Connect output power cables to the output
connectors.
.
All coolant connections have 5/8-18
left-hand threads.
Red
Hose
Yellow
From Power
Source
To IH/TS
110 Volt From
IH/TS
Red
Rear
D Connect the "coolant out" line from
the cooler directly to the output ex-
tension cable.
D Connect the "coolant in" line on
the IH/TS directly to the remaining
output extension cable connection.
D Connect the "coolant out" line from
the IH/TS to the "coolant in" line on
the cooler.
803 036-C