Table of Contents
Advertisement
T
44/64
ALON
Press/ Release: When pressed, raises the upper main
roller over riding the pull roller handle setting. When
pressed again, reverts to current pull roller handle
setting.
Cooling: (Figure 8) When pressed, turns on the cooling
fans. When pressed again, turns off the cooling fans.
JOB When pressed, permits scrolling of job numbers
by turning the MASTER DIAL and is indicated on the
control panel display. Range is 1 - 10. Job 10 is reserved
for running Accushield material.
To store parameters for a particular job number, select the
desired job number location, enter the upper and lower
temperatures and speed, then press JOB.
SPEED: When pressed, permits increasing or decreasing
of speed by turning the MASTER DIAL and is indicated
on the control panel display. Range is 1 - 10.
REV When pressed and held, reverses roller movement
to clear film jams and wrap-ups.
STOP Stops the movement of the rollers.
RUN When pressed, activates rollers for normal
operation.
D. REWINDER SELECTION SWITCH: (Figure 9) This
switch enables the operator to control the function of the
upper rewind/ unwind shafts.
I
In this position, turns the power on to the upper front
rewind/ unwind shaft.
In this position, neither the upper front or upper rear
rewind/ unwind shaft is selected for motor power.
II
In this position, turns the power on to the upper rear
rewind/ unwind shaft.
Page 18
CE
Operations Manual
Fig 8
Fig 9
©2004 General Binding Corporation
Advertisement
Table of Contents
