Rewinder Selection Switch - GBC TALON 44 Operation And Maintenance Manual

II
24
Fig. 8
REWINDER
I
(D)
Fig. 9
Press/ Release
pressed, raises the upper main
roller over riding the pull roller
handle setting. When pressed
again, reverts to current pull roller
handle setting.
Cooling : (Figure 8) When
pressed, turns on the cooling fans.
When pressed again, turns off the
cooling fans.
JOB : When pressed, permits
scrolling of job numbers by turning
the MASTER DIAL
indicated on the control panel
display. Range is 1 - 10. Job 10 is
reserved for running Accushield
material.
To store parameters for a particular
job number, select the desired job
number location, enter the upper
and lower temperatures and
speed, then press JOB
SPEED : When pressed,
permits increasing or decreasing of
speed by turning the MASTER
DIAL and is indicated on the
control panel display. Range is 1 -
I
10.
REV : When pressed and held,
II
reverses roller movement to clear
film jams and wrap-ups.
STOP : Stops the movement of
the rollers.
RUN : When pressed, activates
rollers for normal operation.
D. REWINDER SELECTION
SWITCH: (Figure 9) This switch
enables the operator to control the
function of the upper rewind/
unwind shafts.
I : In this position, turns the power
on to the upper front rewind/
unwind shaft.
: In this position, neither the
upper front or upper rear rewind/
unwind shaft is selected for motor
power.
II : In this position, turns the power
on to the upper rear rewind/
unwind shaft.
: When
and is
.
I