Upper Rewinder Direction Switch; Lower Rewinder Direction Switch; Rear Control Switch; Foot Sw Enable - GBC Talon 44 CE Installation & Operation Manual

Operations Manual
Fig 10
o
TOP 032 F SPEED 03
BOT 032 o F JOB 01
Release

Foot SW Enable

©2004 General Binding Corporation
Fig 11
(H)
Fig 12
E. UPPER REWINDER DIRECTION SWITCH: (Figure 10)
This switch enables the operator to control the direction
of the upper rewind/ unwind shafts.
"FWD.": In this position, the motor runs in a forward
direction.
"STOP": Stops the rewinder motor for the rewind/ unwind
shaft selected.
"REV.": In this position, the motor runs in a reverse direc-
tion.
F. LOWER REWINDER DIRECTION SWITCH: (Figure 10)
This switch enables the operator to control the direction
of the Lower rewind/ unwind shaft.
"FWD.": In this position, the motor runs in a forward
direction.
"STOP": Stops the rewinder motor for the rewind/ unwind
shaft selected.
"REV." : In this position, the motor runs in a reverse
direction.
G. REAR CONTROL SWITCH: (Figure 11) This switch
enables the operator to run jobs from the rear operating posi-
tion of the laminator when rear controls are enabled.
– "REVERSE": In this position, the rollers turn from the
front operating position towards the rear operating
position.
– "STOP": Stops the movement of the rollers.
– "RUN": In this position, the rollers turn from the rear
operating position towards the front operating posi-
tion.
– ENABLE REAR CONTROL SWITCH: To enable
the rear control switch, press and hold JOB
you hear a beep, approximately 3 seconds. REAR
CONTROL replaces READY/ WAIT on the control
panel display.
Replace the rear slitter with the safety shield properly
installed and latched.
– DISABLE REAR CONTROL SWITCH: Press and
hold JOB again to disable the rear control switch.
H. FOOT SW ENABLE: (Figure 12) In this mode
permits operation using the footswitch. Refer to
Item V. FOOTSWITCH for operation.
T 44/64
ALON CE
Page 19
until