Table of Contents
Advertisement
Operations Manual
©2004 General Binding Corporation
O
Fig 5
Fig 6
Fig 7
Control Guide
A. POWER ON/ OFF (I/0): (Figure 5) Located at the back
left of the machine applies power to the laminator. The
control panel display will illuminate when switch is rotated
to the "l" position. The off position, marked "O", removes
power from the laminator.
B. CONTROL PANEL DISPLAY: (Figure 6) Illuminates
when the laminator is plugged in and POWER ON/ OFF
is in the on, (I), position. Displays settings for top heater,
bottom heater, speed, Job, mode and ready/wait/ posi-
tioning indicator.
ROLLER POSITION INDICATOR: Displays the current
main roller position. In figure 7, the roller is shown in the
"Release" position. Refer to Roller Handle for more infor-
mation.
READY/ WAIT INDICATOR: "READY" appears when actual
temperature is equal to (+/- 5) set temperature. "WAIT"
appears when actual temperature is lower than the set
temperature. "WAIT" appears when actual temperature is
higher than the set temperature.
POSITIONING INDICATOR: "Positioning..." appears in
place of the ready/ wait indicator any time the main rollers
are traveling in an upward or downward motion.
C. CONTROL PANEL: (Figure 7)
MASTER DIAL: Increases (+) or decreases (-) the
numeric value for the selected setting when turned.
Press and hold the dial to display actual temperature
of top and bottom main rollers.
Top Temp.: When pressed, permits increasing or
decreasing of the top temperature by turning the
MASTER DIAL
and is indicated on the control panel
display. Range is room temp. to 266°F (130°C).
Bottom Temp.: When pressed, permits increasing or
decreasing of the bottom temperature by turning the
MASTER DIAL
and is indicated on the control panel
display. Range is room temp. to 266°F (130°C).
T
44/64
ALON
CE
Page 17
Advertisement
Table of Contents
