Table of Contents
Advertisement
T
44/64
ALON
Loading Bottom PSA Film
This procedure describes how to load a roll of mount
adhesive using the lower unwind position for decaling
(Figure 28).
1. At this point you should have an upper roll of PSA film
loaded onto the laminator.
2. Ensure no brake tension is applied to the film shaft.
3. Pull the lower roll of film around the lower idler bar
and towards the lower rewind.
4. Place one piece of masking tape in the center of the
film and secure to the rewind tube.
5. Make two full wraps around the rewind tube, then care-
fully score the laminate without cutting the release
liner.
6. Adhere the lower PSA film to the loaded upper roll of
film by pulling the film straight up towards the main
rollers.
7. Reference THREADING CARD PROCEDURE
next.
Loading Bottom Mount Adhesive
This procedure describes how to load a roll of mount
adhesive using the lower unwind position for decaling
(Figure 29).
1. At this point you should have an upper roll of film
loaded onto the laminator.
2. Ensure no brake tension is applied to the film shaft.
3. Adhere the mount adhesive to the loaded upper roll of
film by pulling the mount adhesive straight up towards
the main rollers. Do not web around the lower idler.
4. Reference THREADING CARD PROCEDURE
next.
Page 26
CE
Operations Manual
Fig 28
Fig 29
©2004 General Binding Corporation
Advertisement
Table of Contents
