Vision Fitness Vision series Service Manual page 54

RUNNING BELT/DECK/ROLLER REPLACEMENT
Tools required:
ü Philips screwdriver
ü T-handle key (6mm,5mm)
Procedure:
11. Replace the deck and put the old running belt through the deck and place the deck
with the running belt on the frame.
12. Replace the front roller and rear roller.
13. Tighten the deck screws.
14. Assemble the rear roller first, then assemble the front roller.
15. Place the drive belt on the transmission pulley by turning the flywheel clockwise
by using left hand and place the drive belt on to grooves of the front roller pulley
by using your right hand.
16. Install the front / rear rollers. Adjust the running belt tension bolts to center the
running belt at high speed.
17. Try to step on the belt to check if the belt slips.
18. Install the side rails and secure the end plates.
19. Install the front cover and secure the screws.
(Go to step 13.)
(Go to step 14.)
7-8
(T7400/8400/8500/8600)
Revision: 1.0 Date: 2001-06-01