Running Belt / Deck / Roller (T7200/8200) - Vision Fitness Vision series Service Manual

RUNNING BELT/DECK/ROLLER REPLACEMENT
Tools required:
ü Philips screwdriver
ü T-handle key (6mm,5mm)
Procedure:
9. Remove the deck extension with screwdriver.
10. Replace deck and tighten the deck extension, then install a new running belt.
(Go to step 13.)
5. Turn the flywheel counterclockwise by
using your left hand and pull out the drive belt
from the wheel by using your right hand.
6. Remove the bolts from the front and rear
rollers by using the T-handle key (8mm).
7. Remove the front roller, drive belt and rear
roller. (If replacing the roller, go to step 12.)
8. Remove the 8 screws holding the deck to
the frame then remove the deck with the
running belt. (If replacing the running deck,
go to step 11.)
7-8
(T7400/8400/8500/8600)
Revision: 1.0 Date: 2001-06-01