Vision Fitness Vision series Service Manual page 51

RUNNING BELT/DECK/ROLLER REPLACEMENT
Tools required:
ü Philips screwdriver
ü T-handle key (6mm,5mm)
Procedure:
11. Replace the deck and center the running belt.
12. Tighten the deck screws and assemble the rear roller first, then assemble the front
roller. ( Go to step 16)
13. Replace the front roller and rear roller.
14. Tighten the deck screws.
15. Assemble the rear roller first, then assemble the front roller.
16. Turn the flywheel clockwise with your left hand and place the drive belt onto
grooves of the front roller pulley with your right hand.
17. Install the front and rear rollers and adjust the belt tension screw such that you
can only press with your thumb the belt down 1cm ~ 1.5cm.
18. Install the front / rear rollers. Adjust the running belt tension screw to center the
running belt at high speed.
19. Try to step on the belt at low speed to check if the belt slips.
20. Install the side rails and secure the end plates and all the covers.
(Go to step 15)
7-7
(T-7200/8200)
Revision: 1.0 Date: 2001-06-01