Advertisement
You can be burned if you spill coolant on hot
engine parts. Coolant contains ethylene glycol,
and it will burn if the engine parts are hot
enough. Don't spill coolant on a hot engine.
3. After the engine cools, open the air bleed valves on
the heater return hose and water pump inlet.
4. Fill with the proper
mix. Add coolant until you see a
5. Close the bleed valves.
6. Continue to fill the radiator up to the base of the
7. Rinse or wipe the spilled coolant from the engine
and compartment.
8. Start the engine and allow it to run in idle for
approximately four minutes. By this time, the
coolant level inside the radiator will be lower. Add
more of the proper mix through the filler neck until
the level reaches the base of the filler neck.
steady stream
of
coolant coming from the bleed valves.
filler neck.
5-25
Advertisement
