Advertisement
T-Top Sunshades
An improperly installed T-Top panel may fall
into or fly off the vehicle. You or others could be
injured. After installing a T-Top panel, always
check that it is firmly attached by pushing up on
the underside of the panel.
Reverse the steps above to install the T-top panels.
When installing panels, be sure to align weatherstrips
properly. Panels incorrectly installed may leak.
I
NOTICE:
High pressure car washes
may
cause water to
enter your vehicle. Never spray water directly
at
the roof panel joints. This will cause leaks.
1.
Start with the panel marked DRIVER FRONT.
Unlatch the driver's side T-top, raise it halfway and
close the latch handle.
2. With the top raised and resting on the center roof
rail, slide the flat edge of the sunshade panel (with
the vinyl side to the glass) between the glass and
plastic trim, making sure the edge marked DRIVER
FRONT is pointing to the front of the vehicle.
3 L A
Advertisement
