Rejecting Radar Interference; Adjusting Control Panel Brilliance [Panel Dim] - JRC JMA-3910-4 Instruction Manual

3.2

3.2.9 Rejecting Radar Interference

Attention
If you'll watch the RADAR BECON and the SAFT, set the process as follows.
G
IR OFF
1. Press the
Procedures
2. Press the
3. Press the
the radar interference status.
"IR1", "IR2" or "IR3" then appears on the upper right of the screen to display the
interference rejection circuit operation. "IR3" is most effective for the radar interference.
4. Press the
5. Press the
Exit
Main menu
MAIN MENU
Press an item number key.
1. RADAR ／ TRACK BRILL
2. RR ／ VRM ／ EBL BRILL
3. ARPA BRILL
4. GRAPHIC DATA BRILL
5. PROCESS
6. IR
7. FLOATING EBL
8. VECTOR
9.
To close this menu, Press (MAIN MENU) key.
3.2.10

Adjusting Control Panel Brilliance [PANEL DIM]

Brilliance increases in the four levels every time the
Procedures
and pressing it again returns the system to the original status.
MAIN
key to open the MAIN MENU.
MENU
6
key to select "IR".
6
key to select "OFF", "IR1", "IR2" or "IR3" according to
ENT
key.
MAIN
key.
MENU
G
[DAY1]
G
[DAY1]
G
[DAY1]
G
[DAY1]
OFF PROC1
OFF IR1
OFF ON
TRUE RELATIVE
3 – 13
PROC2 PROC3
IR2 IR3
PANEL
key is pressed
DIM