Antenna Switch; Partial Master Reset; Total Master Reset - JRC JMA-3910-4 Instruction Manual

7.5

7.5.6.2 Antenna Switch

"DISCARD" is set on regular shipment.
Transmission can be enabled while the rotation of the scanner unit is stopped.
1. Follow procedures 1 to 3 in subsection 7.5.6.1 to open the MAINTENANCE
Procedures
MENU.
2. Press the
3. Press the
When "TRANSFER" is selected, transmission is enabled while the rotation of the
scanner unit is stopped.
4. Press the
Exit 5. Press the

7.5.6.3 Partial Master Reset

This function is used to set the same settings as on shipment. Since the contents set by the user are cleared,
only our service personnel is allowed to use this function.
1. Follow procedures 1 to 3 in subsection 7.5.6.1 to open the MAINTENANCE
Procedures
MENU.
2. Press the
3. Press the
mode.
4. Press the
the direction on the screen.
After resetting, the screen which appears after turning the power on is displayed.
Exit 5. Press the

7.5.6.4 Total Master Reset

This function is used by our service personnel after the software is written. Users are
requested never to use this function.
3
key to select "ANTENNA SWITCH".
3
key to select "TRANSFER" or "DISCARD".
ENT
key to confirm the setting.
SUB
key.
MENU
4
key to select "PARTIAL MASTER RESET".
4
key to set the system in the partial master reset standby
ENT
key to reset or the
SUB
key.
MENU
7 – 49
CLR
key not to reset according to