Rejecting Radar Interference; Adjusting Control Panel Brilliance [Panel] - JRC JMA-7710-6 Instruction Manual

3.2

3.2.9 Rejecting Radar Interference

Attention
If you'll watch the RADAR BEACON and the SART, set IR as follows.
IR OFF
1. Press the
Procedures
2. Press the
3. Press the
the radar interference status.
"IR1", "IR2" or "IR3" then appears on the upper right of the screen to display the
interference rejection circuit operation. "IR3" is most effective for the radar interference.
4. Press the
5. Press the
Exit
Main menu
MAIN MANU
1. RADAR/TRACK BRILL
2. RR/VRM/EBL BRILL
3. ATA BRILL
4. GRAPHIC DATA BRILL
5. PROCESS
6. IR
7. FLOATING EBL
8. VECTOR
9. GRAPHIC DATA DISP OFF

3.2.10 Adjusting Control Panel Brilliance [PANEL]

Brilliance increases in the four levels every time the
Procedures
and pressing it again returns the system to the original status.
MAIN
key to open the MAIN MENU.
MENU
6
key to select "IR".
6
key to select "OFF", "IR1", "IR2" or "IR3" according to
ENT
key.
MAIN
key.
MENU
G
[DAY1]
G
[DAY1]
G
[DAY1]
G
[DAY1]
OFF PROC1
OFF IR1
OFF ON
TRUE RELATIVE
3 – 13
PROC2 PROC3
IR2 IR3
PANEL
key is pressed