Squelch Off; Talk Around - Kenwood TK-782 Service Manual

" Selcall Entry
Press [Selcall entry] key to enter the desired Selcall code
you want to call.
A transceivers unit ID is defined by a combination of 3-
digit fleet and 4-digit ID numbers.
To enter Selcall number, use the keypad (keypad model)
or use the [Channel up], [Channel down] keys to select a num-
ber. Then press [C] key to enter the selected number. The
selected digit will shift left to enter the next digit.
Press [D] key to move the cursor 1 position right. Hold
down [D] key ([6] key on a keypad) to clear the entered num-
ber.
" Selcall List
Press [Selcall list] key to enter Selcall list mode.
The ID list code of DMS will appear on LCD.
To select the Selcall list, use [Channel up]/[Channel down]
key or [2]/[8] key on the microphone keypad.
" Selcall + Status Entry
Select the selcall number you wish to call. Press [Selcall
+ Status entry] key to enter "Selcall entry mode". It works as
"Selcall entry mode" mode. If you press [CALL] or [
again, it works as "Status entry mode".
" Selcall + Status List
Select the selcall number you wish to call. Press [Selcall
+ Status list] key to enter "Selcall list select mode". It works
as "Status list" mode. If you press [Selcall + Status list] key
again, it works as "Status list select mode".
" Send GPS
You can send the GPS location data manually. To perform
the operation, you have to install a GPS receiver with NMEA-
0183 output. (GPS receiver must be installed.)
" Shift
It allows you to enable [Shift + Function] key access. When
[Shift] key is pressed, SFT appears on LCD.
" Squelch Momentary
Press [Squelch momentary] key to force the squelch
unmute. "MON" icon appears on LCD and BUSY LED (Green)
lights. If released, the squelch unmutes and "MON" disap-
pears. Also, BUSY LED (Green) goes off.

" Squelch Off

Press [Squelch off] key to force the squelch unmute.
"MON" icon appears on LCD and BUSY LED (Green) lights.
If the key is pressed again, the squelch unmutes and "MON"
disappears. Also, BUSY LED (Green) goes off.

" Talk Around

When Talk around function is activated, "TA" appears and
the transceiver transmits on the receive frequency, using
receiver's QT/DQT code.
The operator can call the other party directly (without re-
peater).
OPERATING FEATURES /
* ] key
"
"
"
"
"
"
"
"
"
TK-782
9