Kenwood TK-782 Service Manual page 28

7-2. Flow Chart
Self programming mode
[ ]
Channel setting mode
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
RF power high/low
[ ]
[ ]
[ ]
Compander yes/no
7-3. Memory Reset Mode
You can clear all settings you made in self programming
mode, or you can return to the original display.
! Press [A] while "SELF PROG" is displayed will change the
display to "CLEAR NO?".
! Press [Channel up/down] to change the display between
"CLEAR NO?" and "CLEAR YES?".
! When "CLEAR YES?" is displayed, pressing [A] will set all
data to default, and "ALL CLEAR" will appear on the dis-
play. Press [A] again to display "SELF PROG".
! When "CLEAR NO?" is displayed, pressing [A] will cancel
the reset, and "SELF PROG" will be displayed.
REALIGNMENT /
[ ]
[C]
RX frequency
[CALL]
[C]/[D]
RX signalling
[CALL]
[C]/[D]
TX freuency
[CALL]
[C]/[D]
TX signalling
[CALL]
[C]/[D]
Scan delete/add
[C]/[D]
[C]/[D]
Beat shift yes/no
[C]/[D]
Wide/Narrow
[C]/[D]
[C]/[D]
Channel selection
[D]
OFF
[CALL]
OFF QT DQT N
[CALL] [CALL]
OFF
[CALL]
OFF QT DQT N
[CALL] [CALL]
!
!
!
!
TK-782
Group selection
DQT I
[A]
DQT I
[A]
27