Revert Channel - Kenwood TK-782 Service Manual

" Revert channel

The revert channel is used to transmit during scanning
and set by the programming software.
1) Priority
The transceiver reverts to the priority channel.
2) Priority with talkback
The transceiver reverts to the priority channel.
If you press PTT during a resume timer (dropout delay
time, TX dwell time) or calling, you can transmit on cur-
rent channel to answer to the call however revert channel
is set to priority channel.
After resume time, scan re-starts and transmission chan-
nel is return to priority channel.
3) Selected channel
The transceiver reverts to the channel before scanning or
the channel that you changed during scan.
4) Last called channel
The transceiver reverts to the last called channel during
the scan.
5) Last used channel
The transceiver reverts to the last used (transmitted) chan-
nel during scan. "Last used" revert channel includes
talkback function.
6) Selected with talkback
The transceiver reverts to the channel before scanning or
the channel that you changed during scan.
" Scan end
When you reactivate the key programmed to the scan func-
tion during scan mode, the scan ends.
The scan icon "SCN" and "#SCAN#" or revert channel
(programmable) display goes off.
" Temporarily delete/add
It is possible to delete or add channel temporarily during
scan. When scan stops on unnecessary channel for example
by interference of the other party, activate the delete/add func-
tion (for example press the key), then that channel is deleted
temporarily and scan re-start immediately.
When you would like to add the deleted channel tempo-
rarily to scan sequence, select the desired (deleted) channel
during scan, activate the delete/add function (for example
press the key) before scan re-start.
That channel is added temporarily to scan sequence. The
temporary deleted or added channels are returns to pre-set
delete/add, when the transceiver exits from scan mode.
" Keypad operation
This parameter selects the default use of the numerical
field of the keypad. You can select from "DTMF", "Selcall
entry", "Status entry" and "OST".
In the case of "OST"; Enter to use the keypad to recall
OST directly. To recall OST memory 1 to 9, press the OST
number directly for 1 second. To recall OST memory 10 to
16, press [ ] for 1 second, then press [0] to [6].
*
Example; Recall OST memory 15 : [
When OST memory is recalled by keypad [1] to [9], the
"OST" display lights and OST is turned on. If the keypad [#]
is pressed, OST is turned off, and the "OST" display goes off.
OPERATING FEATURES /
* ] [5]
"
"
"
"
TK-782
13