Audible User Feedback Tones - Kenwood TK-782 Service Manual

! Maximum ACK Wait Time
Maximum ACK Wait Time is the maximum amount of time
to wait for an acknowledgement from the called radio unit. It
is used as an interval time of retries. It must be set greater
than the ACK Delay Time of the called radio unit.
! ACK Delay Time
ACK Delay Time is the amount of time from the end of
receiving a data to the beginning of sending an
acknowledgement. It should be adjusted as the repeater's
hang-up delay time. Also, it must be set less than the Maxi-
mum ACK Wait Time of the calling radio unit.
! TX Delay Time (RX Capture)
TX Delay Time is the amount of unmodulated transmis-
sion to let the called unit stop scanning or exit its battery
save mode. It is used only when starting a data communica-
tion sequence.
! Data TX Modulation Delay Time
Data TX Modulation Delay Time is the amount of time from
the beginning of transmission to the beginning of a data
modulation. It is used every time data is transmitted.

7. Audible User Feedback Tones

The transceiver outputs various combinations of tones to
notify the user of the transceiver operating state. The main
tones are listed below.
" Power on tone
This tone is output when the transceiver is turned on. (The
high tone is output for 500ms.)
" Alert tone
This tone is output when the transceiver is TX inhibition
for TOT, battery warning and PLL unlocked. It is output until
the PTT button is released.
" Group call tone
Sounds when a group call with the correct DTMF option
signalling is received.
" DMS signalling alert tone
Sounds when an individual call with the correct DMS sig-
nalling is received.
" Individual call tone
Sounds when an individual call with the correct DTMF
option signalling is received.
" Key press tone [A]
Sounds when a key is pressed. For toggle keys, sounds
when toggle function is turned on (key press tone [B] sounds
when it is turned off).
OPERATING FEATURES /
!
!
!
!
"
"
"
"
"
"
TK-782
21