Kenwood TK-782 Service Manual page 18

" Auto Reset
If option signalling matches a group set up with option
signalling, option signalling is released. After matching op-
tion signalling, option signalling will temporarily reset auto-
matically.
" Stun/Kill
If the stun code matches, a predetermined action will oc-
cur. Whether option signalling is activated or not, when stun
code matches on any channel, the transceiver will become
stun or kill.
While stun is active ("LOCK2" appears), if the stun code +
"#" code is received, stun will disactive. While kill is active
("ERROR" appears), the transceiver will be disable all func-
tions. The transceiver must be reprogrammed by the FPU
(KPG-77D) to operation again.
6. Alphanumeric Two-way Paging Function
(Digital Message System : DMS)
" General
The Alphanumeric Two-way Paging Function (DMS) is a
Kenwood proprietary protocol. It enables a variety of paging
functions.
" ID Construction
A radio unit ID is defined by a combination of 3-digit Fleet
and 4-digit ID numbers. Each radio unit must be assigned its
own Fleet and ID numbers.
" PTT ID
A pre-programmed unique ID can be sent at the begin-
ning of transmission and/or the end of transmission to iden-
tify which radio unit is on air.
" Selective Call (SELCALL)
This is a voice call to a particular individual or group of
stations.
! Example of call types;
[100][ALL ] : <Fleet Call>
All the units whose fleet number is "100" are called.
[100][1000] : <Individual Call>
The unit, whose the fleet number is "100" and ID number
is "1000", is called.
[ALL][ALL ] : <Broadcast Call>
All the units are called.
[ALL][1000] : <Supervisor Call>
All ID "1000" are called regardless of their fleet number.
! Unit ID Encode Block
Encode ID Block can be set to limit manual dial ID. The
radio unit will not accept an ID other than these IDs which
are entered from the keypad. If Inter-fleet Call is enabled,
block ID setting affects each fleet group.
OPERATING FEATURES /
"
"
"
"
"
"
!
!
TK-782
17