Priority Channel Setting - Kenwood TK-782 Service Manual

TK-782
3. Scan Operating
" Scan types
! Single group scan
You can scan all valid (ADD) channels in the displayed
group that can be selected with the group up/down key.
! Multiple group scan
You can scan all valid (ADD) channels in the all valid (ADD)
group.
" SCAN start condition
One or more non-priority channels must be added to all
channels that can be scanned. The transceiver must be in
normal receive mode (PTT off).
When you activate the key programmed to the scan func-
tion, the scan starts. The scan icon "SCN" lights and
"#SCAN#" or revert channel (programmable) is indicated
on alphanumeric display.
" Scan stop condition
The scan stops temporarily if the following conditions are
satisfied.
1) A carrier is detected, then signalling matches on chan-
nels for which receive the signalling is set by the program-
ming software.
2) A carrier is detected on the channels for which receiving
signalling is not set by the programming software or when
the monitor (signalling cancel) function is activated.
" Scan channel types
1) Priority channel is the most important channel for the scan,
and always detects a signal during scan and when the
scan stops temporarily.
2) Non-priority channels detects a signal during scan. For
the channels that can be selected with the group or chan-
nel up/down key when the scan does not occur, adds an
indicator " " lights.

" Priority channel setting

A priority channel can be set as follows with the program-
ming software.
1) Specify a priority channel as a fixed priority channel.
2) Make a selected channel, a priority channel.
" Scan type according to the priority channel
1) When no priority channel is set : Only the non-priority chan-
nels are scanned.
If a non-priority channel stops temporarily, it stops until
there is no signal on the channel.
2) When priority channel is set : Either priority channel is
scanned.
If a non-priority channel stops temporarily, a priority chan-
nel signal is detected at certain intervals.
If a priority channel stops temporarily, it stops until there
is no signal on the priority channel.
12
OPERATING FEATURES /
"
!
!
"
"
"
"
"