Thermostat Installation - Quadra-Fire DV-40 Installation, Operation, Venting And Maintenance Instructions

Hide thumbs

Table Of Contents

Table of Contents

If desired, a thermostat may be installed to regulate the Quadra-Fire DV-40 Step. It is important to use a

thermostat designed for millivolt operation. Do not connect this stove to a thermostat serving any other

appliance. Bedroom installation in Canada requires this stove to be hooked to a thermostat.

OPTIONAL THERMOSTATS

Manual Thermostat

Part #812-2880

Anticipator Setting 1.2

Programable Thermostat

Part #811-0520

RECOMMENDED MAXIMUM LEAD

LENGTH (TWO WIRE) WHEN USING

WALL THERMOSTAT/SWITCH

Wire Size

Maximum Length

16 gauge

65 feet

18 gauge

40 feet

20 gauge

25 feet

22 gauge

18 feet

Connect the thermostat wires to the outside terminals labled "TH" and "THTP" located on the valve. Turn

off the manual switch, located on the control panel.

A remote control or a wall switch may be wired to the thermostat terminals. Contact your Quadra-Fire

dealer or service person for details (see page 45 for part number).

The blower cord is located at the rear of the stove, and needs to be routed to a three-prong outlet with

correct polarity. Be sure that the stove is electrically grounded in accordance with local codes, with a

current version of CSA C22.2 No. 3 M1988 (in Canada), or in the absence of local codes, with the National

Electric Code ANSI/NFPA 70-1987.

Do not cut the grounding terminal off under any circumstances.

Do not route the power cord under the body of the stove due to high temperatures.