Table of Contents
Advertisement
Programmable Wall Thermostat Installation
The kit comes standard with a wall thermostat and 25' of
H. Programmable Wall Thermostat Installation
wire. If you need to run more than 25' make sure you use
a continuous strand of 18 to 22 gauge thermostat wire. For
The appliance comes standard with a wall thermostat and 25'
optimum performance your thermostat should be located on
of wire. If you need to run more than 25' make sure you use
an inside wall approximately 5' up from the fl oor.
a continuous strand of 18 to 22 gauge thermostat wire. For
optimum performance your thermostat should be located on
an inside wall approximately 5' up from the floor.
How to Install Your Programmable Wall
How to Install Your Programmable Wall Ther-
Thermostat
mostat
1.
Separate the body of the thermostat from the mounting
1.
Separate the body of the thermostat from the mounting
plate by gently pulling the two pieces apart
plate by gently pulling the two pieces apart
2.
Connect your thermostat wire to the W and R terminals
2.
Connect your thermostat wire to the W and R terminals
(see fi gure below)
(see figure below)
3.
Screw the backer plate to the wall using the hardware
3.
Screw the backer plate to the wall using the hardware
included
included
4.
Snap the thermostat to the backer plate
4.
Snap the thermostat to the backer plate
NOTE: See installation manual for instructions to
5.
Connect the wires to the 2 center screws on the terminal
connect thermostat wire to your appliance.
block on the back of the product
Figure 21.1
1445 North Highway
Colville, WA 99114
Figure 21.2
January 4, 2018
W
R
7014-262B January 29, 2016 Page 1 of 2
Programming Thermostat
The thermostat maintains a desired room temperature.
The 5-2 day programmable function allows one program
Programming Thermostat
for week days and a separate program for Saturday/Sun-
The thermostat maintains a desired room temperature. The
day. (Up to 4 periods per day).
5-2 day programmable function allows one program for week
days and a separate program for Saturday/Sunday. (Up to
Thermostat Controls
4 periods per day).
Thermostat Controls
Function buttons
Press to select the function
displayed just above each
Figure 21.3
button. (Functions change
depending on the task.)
Function buttons
Press to select the function
displayed just above each
button. (Functions change
Saturday and Sunday can be programmed individually
depending on the task.)
by changing the format from 5-2 to 5-1-1. To change
the format :
1. Press and hold the up button and the center button
until the display changes.
Saturday and Sunday can be programmed individually
2. Press up or down to change system function num-
by changing the format from 5-2 to 5-1-1. To change
ber to 16.
the format :
3. Press NEXT to advance to next function.
1. Press and hold the up button and the center button
4. Press up or down to change status number to 1.
5. Press DONE to exit and save settings.
until the display changes.
2. Press up or down to change system function number
to 16.
3. Press NEXT to advance to next function.
4. Press up or down to change status number to 1.
5. Press DONE to exit and save settings.
7082-150C
MT VERNON E2 INSERT-C
Digital display
Digital display
Hold Button
Press to override
programed tem-
perature control
Hold Button
Press to override
Temperature buttons
programed tem-
Press up or down to set preferred
perature control
temperature.
Temperature buttons
Press up or down to set preferred
temperature.
www.quadrafi re.com
21
Advertisement
Table of Contents
