Baffle Removal And Installation; Fan Replacement - Quadra-Fire Pioneer-II-C Owner's Manual

5. Baffle Removal and Installation

WARNING! Hot Surfaces!
Glass and other surfaces are hot during operation AND cool
down. DO NOT clean fireplace until it is cooled.
1. Remove all ash from firebox and place into a metal
container.
2. Remove the baffle protection channel by lifting it up
and turning it down and pulling it out of the firebox.
See Figure 4.5.
Figure 4.5 Removing Baffle Protection Channel
3. Using a 3/16 inch Allen wrench, remove the front
manifold tube retainer bolt on the air channel behind
the end of the front tube on the right side. See
Figure 4.6.
Front manifold tube
Figure 4.6 Remove Retainer Bolt
4. To remove the manifold tube, slide the tube to one
side until one end is out of its hole then pull it down
and out of the other hole. It is only necessary to
remove the front tube in order to remove the baffle.
5. Pull the two (2) piece baffle board and insulation
down and out of the fireplace. See Figure 4.7.
Figure 4.7
22
Remove bolt
Quadra-Fire • Pioneer-II-C Owner's Manual • 4184-900 • Rev C • 02/20
6. To install the baffle board and insulation, repeat steps
2 thru 5 in reverse. Be sure the baffle board and
insulation are pushed back fully and the insulation
is down and flat. See Figures 4.8 & 4.9.
Figure 4.8 Reinstall Baffle Boards
Ba e protector
Figure 4.9 Reinstall Baffle Protection Channel

6. Fan Replacement

CAUTION! Risk of Shock!
ing off circuit breaker before servicing or unplugging
control board from junction box in behind the access
panel..
The Fireplace comes equipped with two fans, installed
at the factory with electric access on both sides of the
fireplace.
1. Remove the bottom firebrick.
2. Remove the four (4) 5/32 Allen head screws and pry
open the access door with a flat blade screwdriver.
See Figure 4.10 and remove it.
Screws (4)
Figure 4.10 Pry Open Access Door
Disconnect power by turn-