Blower - Quadra-Fire DV-40 Installation, Operation, Venting And Maintenance Instructions

BLOWER CLEANING AND/OR REPLACEMENT
Cleaning is recommended at least once yearly or as needed.
1. Disconnect power and turn off gas supply.
2. Unplug blower at molex connector (see "A" below).
3. Remove two screws on back plate of blower compartment.
4. Slide blower compartment away from stove.
5. Vacuum or brush off dust and lint from fan blades.
For Replacement:
Follow instructions above for removal of blower.
Re-install new blower:
1. Key two fingers on the blower compartment into slots on stove back.
2. Connect the molex connector. (See "A" in figure below)
3. Rotate the compartment up.
4. Insert and tighten the two screws.
5. Reconnect power and turn on gas supply.
Take care not to lose the rubber on blower
compartment fingers. If rubber is removed
vibration can occur during blower operation.
Note:
Close up of
molex connection.
Blower compartment fingers.
Page 42
"A"