Optional Log Set Placement Instructions; Thermostat Installation And Operation - Quadra-Fire CASTILE-MBK-B Installation Manual

CASTILE FREESTANDING
E. Optional Log Set Placement Instructions
2 Piece Log Set Installation
1. Open door to expose the firebox.
2. Install the left log first and then the right log. Figure 20.1
3. Lean the logs against the cast iron brick in the back of
the firebox.
4. Push the logs to the far left and far right against the sides
of the firebox. Figure 20.2.
5. To clean the logs, use a vacuum and a soft brush attach-
ment or a paint brush.
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement vari-
ation other than shown here can cause excessive heat and
shall void the appliance warranty.
Figure 20.1
Figure 20.2
20
F. Thermostat Installation
There is a 4 screw terminal block located on the back
lower left corner of the appliance directly above the
power cord inlet. The center 2 screws are for the ther-
mostat wires (see Figure 21.1).
The appliance comes standard with a wall thermostat and 25'
of wire. If you need to run more than 25' make sure you use
a continuous strand of 18 to 22 gauge thermostat wire. For
optimum performance your thermostat should be located on
an inside wall approximately 5' up from the floor.
How to Install Your Wall Thermostat
1. Separate the body of the thermostat from the mounting
plate by gently pulling the two pieces apart
2. Connect your thermostat wire to the W and R terminals
(see Figure 21.2)
3. Screw the backer plate to the wall using the hardware
included
4. Snap the thermostat to the backer plate
5. Connect the wires to the 2 center screws on the terminal
block on the back of the product
Battery Installation and Replacement
NOTE: 2 AAA batteries are included with the thermostat
and must be installed before the appliance can be oper-
ated (see Figure
Install fresh batteries immediately when the REPLACE
BATTERY warning begins flashing. The warning flashes
about two months before the batteries are depleted.
Even if the warning does not appear, you should replace
batteries once a year.
If batteries are inserted within two minutes, the time and
day will not have to be reset. All other settings are perma-
nently stored in memory.
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
7021-154J
21.3).
CAUTION
May 12, 2017