Samsung SRN-1000 User Manual page 22

connecting with other device
if not using a Broadband router
For setting <ip Address>, <Subnet mask>, and <gateway>, contact your network administrator.
4. In the <port> pane, provide necessary information.
• HTTP Port : Used to access the NVR using the Internet browser, defaulted to 80.
Use the spin button to change the HTTP Port value.
• Port(TCP) : Used to control the video signal transfer, defaulted to 554.
5. Enter the password.
The initial administrator ID is "admin" and the password should be set when logging in for the first time.
Please change your password every three months to safely protect personal information and to prevent the damage of the
`
J
information theft.
Please, take note that it's a user's responsibility for the security and any other problems caused by mismanaging a password.
6. Click [oK].
Manual network setup will be completed.
if using a Broadband router
• IP Address : Enter an address falling in the IP range provided
by the Broadband Router.
ex) 192.168.1.2~254, 192.168.0.2~254, 192.168.XXX.2~254
• Subnet Mask : The <Subnet mask> of the Broadband
Router will be the <Subnet mask> of the NVR.
• Gateway : The <Local ip Address> of the Broadband Router
will be the <gateway> of the NVR.
The settings may differ depending on the connected Broadband
`
M
Router model.
For more information, refer to the user manual of the applicable router.
Refer to the "Port Range Forward (Port Mapping) Setup" section of the Broadband Router's documentation. (Page 24)
`
Auto network Setup
Run <ip installer_vx.xx.exe> to display the device search list.
At the initial startup, both [Auto Set] and [manual Set] will be grayed out.
1. Select a NVR in the search list.
Both the [Auto Set] and [manual Set] buttons will be activated.
2. Click [Auto Set].
The Auto Setting dialog appears.
The <ip Address>, <Subnet mask>, and <gateway> will be set automatically.
22_ connecting with other device