Detaching And Refitting The Fuser Heater - Olivetti d-copia 1800 Service Manual

2KL/2KK

(3) Detaching and refitting the fuser heater

Follow the procedure below to replace the fuser heater.
Procedure
1. Remove the fuser unit (see page 1-5-40).
2. Remove two positive terminals of fuser
heater wires from the fuser unit.
Caution
Remove the positive terminals while press-
ing their protrusions.
3. Remove two fuser heater wires from ribs of
the fuser unit.
Caution
Make sure that the fuser heater wires are
not removed from the positive terminals.
4. Separate the right and left fuser unit (see
page 1-5-42).
5. Pull out the fuser heater wire from the rear
side of the right fuser unit and stretch it
straight.
1-5-44
Protrusion
Fuser heater wire
Right fuser unit
Fuser heater wire
Service Manual
Fuser unit
Positive terminal
Fuser heater wire
Positive terminal
Figure 1-5-72
Figure 1-5-73
Y110980-1