Install On/Off Switch; Thermostat Connections; Glass & Catalyst Installation - Vermont Castings stardance 0004050 Owner's Manual

Install ON/OFF Switch

The switch assembly parts are found in the parts bag.
1. Attach switch assembly to left rear side of stove
shroud using two screws and existing holes in
shroud. (Fig. 7)
2. Run wires down back of stove, under bottom of rear
shroud to valve.
3. Attach wires to valve terminals. (Fig. 8)
Switch As-
sembly
Screws
Fig. 7 Attach switch assembly to rear shroud.
SIT Valve
Thermopile
ON/OFF Switch or
Millivolt Thermostat
Fig. 8 Install wiring to switch before connecting to valve.
Thermostat Connection (Optional)
Use only a thermostat rated for 500 - 750 millivolts. FP1622
Do not use low voltage (24V) thermostats.
SIT valve w/switch
Check the table below for the appropriate gauge ther-
mostat wire to use for the length of lead required in your
installation.
Thermostat Wire / Gauge
18
20
22
1. Install the wall thermostat in the desired location and
run the wires to the stove location. Terminate these
leads with 1/4" female connectors.
2. Connect the thermostat wires to the valve. (Fig. 9)
30005057
Existing
Holes
ST315
Valve
FP1622
ST315
attach switch assy
1/31/00 djt
Maximum Run
40 feet
25 feet
16 feet
Stardance® Vent-Free Gas Heater
On/Off Switch Wiring
TP/TH
TP
TH
Thermostat
Optional Thermostat/Remote Wiring
TP/TH
TP
TH
Fig. 9 ON/OFF switch and optional Thermostat/Remote wir-
ing.
Glass & Catalyst Installation
St124c
CAUTION: Air shutter on Natural Gas units
Thermostat
must be adjusted when installing glass and
wiring
catalyst for proper operation. LP units do
1/11/00 djt
not use an air shutter.
1. Remove screen. (Fig. 10) Remove rear, left and right
log bracket assembly by unfastening the two screws
which hold the burner in place.
Fig. 10 Remove screen.
ON
OFF
Black
(Optional)
Thermostat/Remote
(Optional)
St124b
on/off/switch
wiring
1/11/00 djt
Black
Millivolt
Gas Valve
Screen Hooks
Millivolt
Gas Valve
ST124b
ST124c
ST713
9