Complete The Installation - Vermont Castings stardance 0004050 Owner's Manual

Complete the Installation

1. Install the screen frame by sliding the hooks over the
top front edge of the firebox and resting the bottom
on the support brackets. If the catalyst has been
installed, place the glass front on the stove by resting
the bottom edge of the frame on support brackets
below the front opening of the firebox. Rotate the top
edge of the assembly toward the firebox, and center
it. Rotate the right and left cams towards the back of
the firebox to secure glass frame in place.
2. Grasp the front plate by the window bars and lift
into position engaging the two steel tabs behind the
adjacent bosses in the side plates. (Fig. 17) Seat the
front against the sides so the tabs at the bottom lip
engage with the notches in the stove legs.
Engage steel tabs
behind the cast
iron bosses
Fig. 17 Install the Front Plate. Your Front may look different
from that shown.
30005057
Control Door
Bottom Tabs engage
notch in the leg.
ST112b
ST112a
front plate install
fully assembled
1/04
Stardance® Vent-Free Gas Heater
When properly installed, the bottom of the front plate
cannot be pulled away form the sides without lifting it.
NOTE: Be sure the control door can swing out. It
should close against the steel tab stop.
If installing the optional warming shelf, you may find it
easiest to attach it to the top plate before placing the
top in position on the stove. Follow the instructions sup-
plied with the kit.
3. Lay the screen and top grille in place. (Fig. 18)
This completes assembly of the Stardance.
Levelling
Screws
Fig. 18 Install the Top Plate and Grille.
ST114a
top install
12/18/03 djt
Grille
Screen
ST114b
13