Vermont Castings stardance 0004050 Owner's Manual page 12

Stardance® Vent-Free Gas Heater
3. Install the right log by placing it on the sheet metal
bracket behind the grate with the right end of the log,
"the thicker end", touching the grate and the right
side the firebox. Swing the left end of the log "paint-
ed end", backward until it comes in contact with the
branch on the rear log. Set the log down over the
bent tab on the right. When the log is in place it rests
on the tab mentioned earlier and the tip of it comes
in contact with the branch on the rear log. (Fig. 15)
Left Log
Rear Log
Fig. 15 Install rear, left and right logs.
LG223
UVS27
log placement
1/30/02 djt
12
Right Log
LG223
4. Install the left log by placing it on the sheet metal
bracket behind the grate with the left end of the log,
"the thicker end" touching the grate and the left end
of the firebox. Lay the log into the recessed area
on the left branch of the rear log. When the log is
in place, it will rest on the left branch of the rear log
toward the left side of the branch.
5. Loosely sprinkle the lava rocks directly on top of the
burner just behind decorative grate. (Fig. 16) Do not
place lava rocks toward back of burner. The lava
rock is shipped inside the bag assembly.
Fig. 16 Stardance logs in place.
LG224
UVS27
logs in place
1/30/02 djt
30005057
LG224