Install On/Off Switch; Thermostat Connection (Optional) - Vermont Castings 0003380 Operating Manual

Hide thumbs Also See for 0003380:

Homeowner's installation and operating manual (28 pages)

Installation and operating instructions manual (24 pages)

Table Of Contents

Table of Contents

•

Thread the retaining nut onto the shaft of the

rheostat, tightening with a wrench. Do not over-

tighten.

•

Attach the control knob to the rheostat shaft.

•

Use the wire tie to secure the fan and rheostat

wire harnesses together.

12. Plug the power cord into a standard grounded 110

volt household outlet. If the fan control knob is not

turned to the OFF position, the fan will turn on when

the temperature at the snapstat reaches approximately

109° F.

Retaining Nut

Control Knob

Fig. 13 Attach rheostat to control panel. Valve may look dif-

ferent.

MOTOR

BLK

POWER

Fig. 14 #2767 / FK26 Fan Wiring Diagram

WARNING

ST196

The optional fan kit is equipped with a three-prong

FK26 fan diangram

(grounding) plug for your protection against shock

11/99

hazard and should be plugged directly into a prop-

erly grounded three-prong outlet. Do not cut or

remove the grounding prong from this plug.

NOTE: If you are installing the fan kit after the stove is

in its final location, follow same steps mentioned previ-

ously with the exception of disengaging only the right

side of the outer shroud.

30005056

Rheostat

ST347a

JUV

Disconnect power

before servicing.

FK28

rheostat install

BLK

SNAPSTAT

9/21/00

WHT

ON/OFF

RHEOSTAT

The switch assembly parts are found in the parts bag.

1. Attach switch assembly to left rear side of stove

shroud using two screws and existing holes in

shroud. (Fig. 15)

2. Run wires down back of stove, under bottom of rear

shroud to valve.

3. Attach wires to valve terminals. (Fig. 16)

Switch As-

sembly

Screws

Fig. 15 Attach switch assembly to rear shroud.

SIT Valve

ST347a

Thermopile

ON/OFF Switch or

Millivolt Thermostat

Fig. 16 Install wiring to switch before connecting to valve.

Thermostat Connection (Optional)

ST196

Use only a thermostat rated for 500 - 750 millivolts.

Do not use low voltage (24V) thermostats.

Check the table below for the appropriate gauge ther-

mostat wire to use for the length of lead required in your

installation.

Thermostat Wire / Gauge

1. Install the wall thermostat in the desired location and

run the wires to the stove location. Terminate these

leads with 1/4" female connectors.

2. Connect the thermostat wires to the valve. (Fig. 16)

Radiance® Vent-Free Gas Heater