Control systems
COMAND navigation system (entering a destination)
Select "Back" and press n.
i
The "Back" menu item is only present if this
list was called up from the list with input charac-
ters.
Confirming selection: Press n.
Starting route calculation:
Select "Start", see also ( page 171).
Entering a destination from the list of
last destinations
Select "Navi"
"Destination"
"From Last Destinations".
The list of last destinations appears.
The most recent destination is at the
top of the list.
Select desired destination.
Starting route calculation:
Select "Start", see also ( page 171).
174
Entering a destination from the map
i
Depending on the factory settings of the ve-
hicle, it may not be possible to enter a destina-
tion while the vehicle exceeds a preset speed. As
soon as the vehicles speed drops to below the
preset speed, the function is available again.
You can enter a destination via the map if the dig-
ital map does not contain the address of the des-
tination, but the destination must be within the
area of the digital map.
Calling up the map
In the address input menu, select
"Map" ( page 153).
You will see the map with a crosshair.
The map is set to the address set in the
address input menu.
or
Select "Navi"
"Destination"
"Via Map".
You will see the map with a crosshair.
1 Crosshair
2 Details of the crosshair position
3 Map scale
i
Display 2 may be the name of a road, for
example, provided the digital map contains the
necessary data.
If no data is available, display 2 shows:
the coordinates if the geo-coordinate display
is switched on ( page 151)
no display if the geo-coordinate display is
switched off ( page 151)