Table of Contents
Advertisement
Control systems
COMAND introduction
i
®
By selecting "LOGIC7
OFF", all compatible
formats as they are present on the medium are
played back. Due to the vehicle's spatial charac-
teristics, an optimal sound experience is not en-
sured on all seats.
Adjusting surround sound
With surround sound, you can choose be-
®
tween "LOGIC7
ON" and "LOGIC7
Select "Sound"
"3D Sound".
Adjusting surround sound
1 Current setting
92
Selecting a setting: Slide
rotate ymz.
Saving setting: Press n
The setting is saved and the menu is
closed.
Exiting menu without saving chang-
es: Press L or slide omp.
®
OFF".
i
Please note the following:
For an ideal sound experience at all seats,
the balance and fader should be adjusted to
the center of the passenger compartment
®
with LOGIC7
switched on.
The best sound results are achieved by play-
ing high-quality audio CDs and audio DVDs.
For MP3 tracks, the bit rate should be at
least 128kBit/s.
Surround sound does not function for
mono-signal sources.
In the event of poor radio reception quality,
e.g. inside a tunnel, you should switch off
LOGIC7®, as a dynamic switch from Stereo
to Mono could occur, resulting in temporary
sound distortion.
rmq
or
With some stereo recordings, the resulting
sound may deviate from conventional stereo
playback.
Switching off/on the audio source
i
When you insert an audio CD or audio DVD,
it automatically becomes the active audio
source.
Switching off: Select "Audio"
dio"
"Audio OFF".
The audio source is switched off; "Au-
dio OFF" appears in the display.
Switching on: Select "Audio", then the
desired audio source.
or
Load CD/DVD ( page 107) or a
PCMCIA card ( page 108).
"Au-
Advertisement
Table of Contents
