Table of Contents
Advertisement
If you have accepted the call using the
Bluetooth headset, the call will be conduct-
ed via the headset.
Further operating functions can be found
in the "Functions during a single-call con-
nection" section ( page 127).
You can also accept a call if the
COMAND display is showing a screen oth-
er than the telephone mode screen. After
accepting the call, you will see the caller's
data in a window.
qmr
Closing window: Slide
or press n.
Making an outgoing call
i
If you place an outgoing call and receive a
busy signal, the telephone automatically starts
to redial as long as the provider and the mobile
phone support this function (see mobile phone
operating instructions).
While the call is connecting, you can also send
character strings ( page 127).
Entering the telephone number using
the COMAND controller
Switching screen to telephone
mode: Call up main telephone menu
( page 121).
Entering digits: Select desired digits
ymz
by rotating
press n.
Deleting individual digits: Select )
and briefly press n.
Deleting an entire telephone num-
omp
or
ber: Select ) and press and hold n
until the telephone number is deleted.
Connecting a call: Select "S".
Entering a telephone number using the
telephone keypad
Switching screen to telephone
mode: Call up main telephone menu
( page 121).
Use telephone keypad to enter digits.
i
using the telephone keypad can be found on
( page 82).
Connecting a call: Press s.
Redial
omp
Switching screen to telephone
or sliding
and
mode: Call up main telephone menu
( page 121).
Use COMAND controller to select
"S".
or
Press s on the telephone keypad
( page 82).
The list of dialed numbers appears. The
most recently dialed number is at the
top.
Select desired entry.
Connecting a call: Press n.
i
the "S" menu item cannot be selected and the
s button on the telephone keypad does not
function.
Control systems
COMAND telephone*
A detailed description of how to enter digits
If the list of dialed calls contains no entries,
125
Advertisement
Table of Contents
