Table of Contents
Advertisement
Map data is already installed
You will see a message that the map data
is already installed and a prompt will ap-
pear asking you whether you want to con-
tinue with the update.
Select "Yes" or "No".
If you select "No", COMAND automati-
cally ejects the DVD and the map data
is not updated.
Take DVD out of slot.
If you select "Yes", the existing map
data is saved again.
Updating the map data
While the update is running, you will see a
message to this effect and a progress bar.
The progress bars fills up from left to right
during the update.
1 Progress bar
You can either cancel the update or allow
it to run to the end without canceling.
Canceling an update on the single
DVD drive: Press eject button 2.
Canceling an update on the DVD
changer: Press corresponding maga-
zine tray button 2.
The DVD will be ejected in both cases.
Take DVD out of slot.
Control systems
COMAND navigation (introduction)
i
If the update is canceled, the navigation sys-
tem remains fully operational with the previous
map data. You can restart the update at a later
date. It will then continue from the point where it
was canceled.
To allow the update to run to the
end without canceling: take no fur-
ther action.
If the update is successfully complet-
ed, you will see a message to this ef-
fect.
Confirming message: Press n.
COMAND ejects the DVD.
Take DVD out of slot.
The update is complete.
If the update is not successfully complet-
ed, you will see a message that the map
update is not possible.
Confirming message: Press n.
COMAND ejects the DVD.
Take DVD out of slot.
143
Advertisement
Table of Contents
