Table of Contents
Advertisement
This may cause injury to you or others, or
damage the vehicle or objects.
Mounting tires/rims of other specification
than the original equipment tires/rims may
impair the function of the Dynamic Rear
View Monitor. Contact an authorized
Mercedes-Benz Center.
Warning!
Use of Dynamic Rear View Monitor can be
dangerous if you are color-blind or have im-
paired color vision.
Only use Dynamic Rear View Monitor if you
can see and distinguish all colored guide
lines shown by Dynamic Rear View Monitor
on the COMAND display.
Switching on Dynamic Rear View Moni-
tor
i
The Dynamic Rear View Monitor must be ac-
tivated in the instrument cluster control system
in order for it to be switched on ( page 253).
Switch on the ignition ( page 315).
Switch on COMAND ( page 79).
Move gear selector lever to position R
(reverse gear).
The COMAND display will show the
area behind the vehicle with guide lines
to help you reverse into a parking
place.
G
i
If you activate a different function on the
driver's COMAND controls while reverse parking
or parallel parking, the image from the back-up
camera is interrupted.
To reactivate the camera, take the vehicle out of
reverse gear and then re-engage reverse gear
again.
Reverse parking (back-in parking)
Controls in detail
Driving systems
This function helps you when you are re-
versing in a straight line or backing in at
any angle.
The space required by the vehicle for re-
versing is shown by guide lines.
When you turn the steering wheel to a
straight-ahead position, you will see the
guide lines on the COMAND display in the
following order:
1 Yellow and blue guide lines for vehicle
width
2 Yellow 13 ft (4 m) guide line
3 Yellow 39 in (1 m) guide line
4 Red 10 in (0.25 m) guide line
415
Advertisement
Table of Contents
