Table of Contents
Advertisement
Controls in detail
Driving systems
Use the COMAND controller
( page 82) to select "parallel parking"
function 2.
You will see the guide lines for parallel
parking on the COMAND display.
Back up carefully parallel to parked car
until the respective vertical blue guide
line 1 is at the end of the parked vehi-
cle next to you.
Stop the vehicle.
Warning!
If the respective vertical guide line 1 is not
yet located at the end of the parked vehicle
and you are already turning into the parking
space, you could collide with the parked ve-
hicle. Stop the parking procedure immedi-
ately. Pull out of the parking space and start
the parking procedure over again.
418
1 Vertical blue guide line
3 Extended blue guide line
4 Blue guide lines for vehicle contour
G
With the vehicle at a standstill, turn
steering wheel in parking direction until
blue guide lines 3 and 4 appear and
the rectangle formed by guide lines 4
shows the desired parking position. If
another vehicle is located next to you,
the extended blue guide line 4 must
just touch the corresponding vertical
blue guide line 1.
i
If an obstacle is inside of or protrudes into
the area marked by blue guide lines 4 for the
vehicle, the parking space is too small for the ve-
hicle.
i
If you turn the steering wheel too far, the
message "Steering wheel turned too far. Please
adjust steering wheel" appears on the COMAND
display. Turn the steering wheel back until the
message disappears and the extended blue
guide line 4 intersects with vertical blue guide
line 1.
If you back up using the wrong wheel angle, the
following appears in the COMAND display:
"Steering wheel turned too far. Park Assist dis-
abled.". Pull out of the parking space and start
the parking procedure over again.
Advertisement
Table of Contents
