Table of Contents
Advertisement
Control systems
COMAND navigation system (entering a destination)
If COMAND finds destinations, you will
see a list of the destinations and details
of how far away they are in the
right-hand side of the display. The in-
formation about how far away the des-
tinations are can take a few seconds to
be displayed.
The left-hand part of the display shows
the destinations on the map. The desti-
nation marked in the list is highlighted
in the map.
Selecting a destination: Select the
desired destination from list.
The address of the destination ap-
pears.
Starting route calculation:
Select "Start", see also ( page 171).
Entering another destination as a stop-
over
Select "Navi"
"Destination"
"Stopover".
Entering: Select "Other".
176
You can select between the following
menu items:
"Address Entry"
"From Memory"
"From Last Destinations"
"From POIs"
Select a menu item.
Subsequent destination entries may differ,
depending on your selection:
"Address Entry" selection:
Enter a destination by address
( page 153).
"From Memory" selection:
Enter a destination from the desti-
nation memory ( page 172).
"From Last Destinations" selection:
Enter a destination from the list of
last destinations ( page 174).
"From POIs" selection:
Enter a special destination
( page 177).
Starting route calculation: after en-
tering a destination, select "Start"
( page 171).
Changing a stopover
If a stopover has already been entered, you
can change it.
Select "Navi"
"Destination"
"Stopover"
"Change Stopover".
Enter another destination as a stop-
over.
Deleting the stopover
If a stopover has already been entered, you
can delete it.
Select "Navi"
"Destination"
"Stopover"
"Delete Stopover".
COMAND deletes the stopover and cal-
culates the route to the main destina-
tion.
Advertisement
Table of Contents
