Table of Contents
Advertisement
Control systems
COMAND telephone*
Placing a call to a call list entry or
COMAND phone book entry
Call up a call list and select an entry
( page 122).
or
Call up COMAND phone book and se-
lect an entry ( page 129).
Connecting a call: Press n.
Speed dialing
You can save telephone numbers in the
speed-dial preset locations on the mobile
phone and call up the speed-dial presets
(see mobile phone operating instructions).
i
By default, the mailbox number is preset in
the speed dial memory unless you have modified
it. For more information on the mailbox
( page 121).
You can also call up speed-dial numbers
using COMAND.
i
Operation during call connection depends
on the speed-dial preset position called up.
126
Calling up speed-dial presets using the
COMAND controller
Switching screen to telephone
mode: Call up main telephone menu
( page 121).
Entering number of a speed-dial pre-
set: Select all the digits in sequence.
Deleting individual digits:
Select ) and briefly press n.
Deleting entire number:
Select ) and press n until the
number is deleted.
Connecting a call (speed-dial pre-
sets 1 -99): Select "S".
or
Connecting a call (speed-dial pre-
sets 100 - 999): Select "#" after the
digits
"S".
In both cases, the telephone connects
the call to the saved telephone num-
ber. If the speed-dial memory contains
no telephone numbers, you will see a
corresponding message.
Deleting message: Press n.
Calling up speed-dial numbers using the
telephone keypad
Switching screen to telephone
mode: Call up main telephone menu
( page 121).
Single-digit numbers: Press and hold
A - 9 buttons.
or
Single- and two-digit numbers: Enter
number using the A - 9 buttons.
Press s.
or
Three-digit numbers: Enter number
using the A - 9 buttons.
Press #, and then s.
In all three cases, COMAND connects
the call to the saved telephone num-
ber. If the speed-dial memory contains
no telephone numbers, you will see a
corresponding message.
Advertisement
Table of Contents
