Victory 2012 Ness Signature Series Rider's Manual page 77

Mechanical Clutch Lever Lubrication
1. Remove the right side access cover. Loosen the clutch
cable adjuster lock nut.
2. Turn the cable adjuster completely inward to provide
maximum lever freeplay.
3. Remove the clutch lever pivot nut and screw. Disconnect
the clutch cable from the clutch lever.
4. Remove any old grease and dirt from the lever and
housing. Lubricate the clutch lever and pivot screw with
VICTORY Moly Assembly Grease or VICTORY All
Purpose Grease.
5. Reconnect the clutch cable. Reinstall the lever, pivot
screw and nut. Hold the screw down and tighten the nut.
Torque: 40 in-lbs (5 Nm)
6. Adjust clutch lever freeplay. See page 72.
Mechanical Clutch Cable Lubrication
Lubricate control cable ends at the intervals recommended in the periodic maintenance table
beginning on page 58.
NOTICE: External casings are factory-lubricated. Additional lubrication could be detrimental to cable
performance.
Verify proper routing and smooth movement. Inspect for damage to the external casing, and
inspect exposed cable wire for fraying, kinks or corrosion. Replace any damaged, sticky or
sluggish cable.
1. Disconnect the cable at the clutch lever and at the primary cover.
2. Lubricate the barrel ends with VICTORY All Purpose Grease or equivalent.
3. Reconnect the cable and adjust freeplay as needed.
Maintenance
Pivot Screw
Pivot
Nut
AP
73