Victory 2012 Ness Signature Series Rider's Manual page 57

Using Cruise Control
Resume Speed
1. Disengage the cruise control with the brake, throttle or clutch.
2. Press the resume button (RES) to return to the set speed.
(Type R: You must wait at least 3 seconds after disengag-
ing cruise control before pressing resume. If the resume
button is pressed within 3 seconds of disengaging, the
cruise control may not engage, even if the indicator illu-
minates. This is a safety feature that prevents cruise con-
trol from engaging if a button is stuck. To continue using
cruise control, disengage it and wait 3 seconds before
pressing resume.)
Tip: Turning the cruise control master switch off will erase the set
speed from memory and disengage the cruise control.
Accelerate
Tap and release the accelerate (ACC) button to increase speed
in approximately 1 MPH (1-2 km/h) increments. Press and hold the ACC button to accelerate
to a new SET speed (resets when button is released). On vehicles without Type R cruise con-
trol, the speed will reset when the button is released or after a maximum acceleration of
approximately 10 MPH (16 km/h), whichever comes first.
Tip: If you use the throttle to accelerate and then release it, the cruise control will resume the previ-
ously set speed.
Decelerate
Tap and release the decelerate (DEC) button to decrease
speed in approximately 1 MPH (1-2 km/h) increments. Press
and hold the DEC button to decelerate to a new SET speed
(resets when button is released), or to the minimum cruise
speed of 25 MPH (40 km/h).
Cancel Cruise Control
To temporarily cancel the cruise control and allow use of the
resume feature:
• apply the brakes
• close the throttle
• disengage the clutch
To cancel the cruise control and erase the set speed from memory, press OFF.
Operation
Resume
Accelerate
Off Decelerate
53