Table of Contents
Advertisement
Once the system macros have been created, they are available for use on a
port-by-port basis. They get selected on a port's Port Configuration
Properties page (see Port Level, page 120 for details).
Note: 1. Information about the Search function is given on page 63.
2. You can choose only one system macro per port.
3. Systems macros are stored on the switch, therefore macro names may
not exceed 64 Bytes; hotkey combinations may not exceed 256 Bytes.
(Each key usually takes 3–5 Bytes.)
Chapter 5. The User Interface
→
Port
65
Advertisement
Table of Contents
