ATEN KN1108V User Manual page 28

KVM Over the NET™ User Manual
No. Component
1 Power Sockets
2 Power
Switches
3 PON Port
4 Secondary
Serial Port
5 Secondary LAN
Port
6 Grounding
Terminal
7 Modem Port
8 Primary Serial
Port
9 Primary LAN
Port
10 Local Console
Port(s)
11 KVM Ports
12
The power cables plug in here.
This standard slide switch powers the unit on and off.
This connector is provided for a Power over the Net™
(PON) unit which allows servers attached to the KVM Over
the NET™ switch to be booted remotely over the net.
See Single Stage Installation, page 19, step 6 for
installation details. Contact your dealer for more information
regarding PON units.
This port is provided to connect to legacy serial devices via
an SA0142 adapter.
The cable that connects the unit to the backup network
interface (10/100/1000 Mbps) plugs in here.
The wire used to ground the unit connects here.
For dial in connection should the unit be unavailable over
the network. See Single Stage Installation, page 19, step 7
for installation details.
This port is provided to connect to legacy serial devices via
an SA0142 adapter.
The cable that connects the unit to the primary network
interface (10/100/1000 Mbps) plugs in here.
The unit can be accessed via a local console as well as over
the Net. The local console devices (keyboard, monitor and
mouse), plug in here. Any combination of USB and PS/2
keyboards and mice can be used.
Note: For the KN2124v, KN2140v, KN4124v and the
KN4140v units, use the 5-in-1 cable supplied with the
package to connect your console devices to the unit.
The Cat 5e cables that link the unit to the KVM Adapter
Cables (which connect to the servers), plug in here.
Description